CB-ACC-36【PDF 9/58 页】ANTENNA 1/2WV 2.4GHZ 10CM RPSMA

Version 1.17 2011-09

2 Electrical Interface and Connectors

This section describes the signals available on the module interface connectors.

There are four ways to connect to the OEM Serial Port Adapter:

" Via the PCB solder pads on the edge of the PCB, J6 (see Picture 4). See Section

5.4 for more information.

" Via the 2x20-pin 1mm pitch board-to-board (one piece part) connectors, J2 through

J3. The J2 to J3 connectors on the OEM Serial Port Adapter exist on the module on-

ly as a mating PCB-layout pattern (see Picture 5). See Section 5.2 for more infor-

mation.

Optional:

" Via the JST connector, J8 (see Picture 6). The connector is a 6 poles wire connect-

or. The pitch is 1mm and the. The connector is from JST with part number SM06B-

SRSS-TB.

" Via the flexfilm connector, J7 (see Picture 7). The connector is a 16 poles flexfilm

connector. The pitch is 0.5mm and the flexfilm should be 0.3mm thick. The connect-

or is from Hirose with part number FH19S-16S-0.5SH(05).

Picture 4: J6 are available on the edge of the cB-

0901.

Picture 5: J2 to J3 are available on cB-0901. Some

of the not used pads are not visible.

Picture 6: JST 6-pol connector, J8.

Picture 7: Flexfilm connector, J7.

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购